|
|
| Line 1: |
Line 1: |
| cs:Connected st:''''''Primary/Unknown''' ds:UpToDate/DUnknown''' r---
| |
| ns:0 nr:0 dw:1036 dr:3111 al:0 bm:98 lo:0 pe:0 ua:0 ap:0
| |
|
| |
|
| (a) If the cluster (/OPT) is mounted on '''Primary''' node and showing above error,then run the following commands.
| |
|
| |
| (1) drbdadm -- --discard-my-data connect all (on '''Node2''' with "bad" data)
| |
|
| |
| (2) drbdadm connect all (on '''Node1''' with "good" data)
| |
|
| |
|
| |
| After running those commands check '''Node1''' .
| |
|
| |
| (3) service drbd status (It will show that data is syncing to '''node2''' disk)
| |
|
| |
|
| |
|
| |
|
| |
| cs:WFConnection st:''''''Secondary/Unknown'''''' ds:'''UpToDate/DUnknown''' C r---
| |
| ns:0 nr:0 dw:0 dr:0 al:0 bm:17 lo:0 pe:0 ua:0 ap:0
| |
|
| |
|
| |
| (a) If the cluster (/OPT) is mounted on '''Secondary''' node and showing above error,then run the following commands.
| |
|
| |
| (1) drbdadm -- --discard-my-data connect all (on '''Node1''' with "bad" data)
| |
|
| |
| (2) drbdadm connect all (on '''Node2''' with "good" data)
| |
|
| |
|
| |
| After running this command check '''Node2''' .
| |
|
| |
| (3) service drbd status (It will show that data is syncing to '''node1''' disk)
| |
